South australian
rifle association

EST. 1861

| Case Holder - Wilson Ph 357

Case Holder - Wilson PH 357

Case Holder - Wilson PH 357

For 357 Mag

To Hold Straight Walled Pistol Cases for Trimming

Cases Must be Pressed in and Out of Holder

Designed to be used with FIRED Cases - to Aid in Crimping

These Hardened Holders (for fired cases only) are available in .38 Special, .38 Super Auto, .357 Magnum, .44 Special, .44 Magnum, .40 S&W, .45 Auto, .45 Colt and 10 mm.  All these have practically no body taper and require a special type holder, which is constructed very much like a neck sizing die.

Cases can’t be “bumped” in and out of these holders like most rifle cases but must be forced in with a light arbor press or mallet and must be driven or pushed out.

These holders are made longer than the cases to be trimmed so that cases may be forced clear in without damage to case mouth. Holders are counter-bored at mouth end for cutter clearance. 

Users will find the case trimmer somewhat slower on pistol cases than on rifle cases but it will produce a very uniform case length with consequent perfection in crimping.

$25.00
1 In stock